Operation
66
Pos: 32.18 /Übersc hriften/Überschri ften 3/A-E/B/Bei Var iante Plus @ 360\mod_143937 2182647_78.docx @ 2666578 @ 3 @ 1
9.2.3 For Plus Version
Pos: 32.19 /BA/Bedienun g /Schwader/Krei selarme senken/heben/ Auslegearme senken -ele ktrisch_Bild Swadr o TC 680_760 @ 362\mod_143956439 8575_78.docx @ 2670521 @ @ 1
SW700067_2
2
1
4
3
5
I
II
III
Fig. 35
Pos: 32.20 /BA/Bedienun g /Schwader/Krei selarme senken/hebenAus legearme senken -elek trisch_Text Swadro TC 680_760 @ 395\mod_144664280 6746_78.docx @ 2816375 @ @ 1
• Fasten operation panel (4) in the cabin.
• Start tractor.
• To switch on the operation panel, move switch (3) to position 1.
• Move switch (5) to central position (II).
• In order to relieve the lockings (1), actuate the single-action control unit on the tractor and
pressurize the hydraulic cylinders.
• To release the lockings (1), pull the actuating rope (2) and keep it tensioned.
• Set the single-action control unit (red 1+) of the tractor to float position.
• If the rotors are in the working position, release the actuating rope (2).
• To switch off the operation panel, move switch (3) to position 0.
• Switch off tractor and secure it against rolling away.
Pos: 32.21 /BA/Bedienun g /Schwader/Krei selarme senken/heben/ Hinweis Kreiselarme s enken ohne Einschhalten d er Bedieneinheit @ 303\ mod_1414414735689_78. docx @ 2358707 @ @ 1
Note
The changeover of the outrigger arms from the transport position into working position can also
be performed without the operation panel being switched on. In this case, both outrigger arms
are always activated at the same time.
Pos: 32.22 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
