Operation
73
Pos: 32.51 /Übersc hriften/Überschri ften 2/A-E/AArbeitsbr eite einstellen @ 77\ mod_1310103035622_78. docx @ 667585 @ 2 @ 1
9.7 Adjusting the Working Width
Pos: 32.52 /BA/Sic herheit/8. Voraussetz ungen/Handlungsan weisung für alle Maschi nen/Handlungsan weisung: Maschine stills etzen und sichern @ 274\mod_1404365253849_78.doc x @ 2065151 @ @ 1
• Shut down and safeguard the machine, see chapter Safety -> Safety routines, "Shutting
down and safeguarding the machine".
Pos: 32.53 /BA/Bedienun g /Schwader/Bei Ausf ührung mechanische Arbei tsbreitenverste llung: @ 77\mod_13103 72030273_78.docx @ 66810 5 @ @ 1
For design with mechanical working width setting:
Pos: 32.54 /BA/Bedienun g /Schwader/Ausführ ung mechanische Arbei tsbreitenverstel lung Bild SW 700_ 800_900 @ 77\ mod_1310545909337_78. docx @ 669049 @ @ 1
2
SW700056
3
1
2
1
34
Fig. 43
Pos: 32.55 /BA/Bedienun g /Schwader/Ausführ ung mechanische Arbei stbreitenverstel lung Swadro TC 680_760 @ 303\ mod_1414132276881_78.d ocx @ 2356856 @ @ 1
• In order to set the working width, lower the rotors until the guide wheels are located a little
above the ground.
• Stop and secure the machine, refer to chapter Safety Safety Routines “Stopping and
Securing the Machine”.
• Remove special key (1) from threaded spindle (2).
• Loosen counter nut (3).
• Set the desired working width via threaded spindle (2) by using the special key (1).
• CAUTION! In order to meet the transport height, retract rotors completely.
• Secure threaded spindle (2) by using counter nut (3).
• Put special key down on the threaded spindle and secure with spring cotter pin (4).
Pos: 32.56 /BA/Bedienun g /Schwader/Abstan d der Kreisel zum Schwadfor mer @ 77\mod_1310104344400 _78.docx @ 667697 @ @ 1
The distance between the rotors and the swath former:
high amount of forage = long distance
small amount of forage = short distance
Pos: 32.57 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1
To Next Page
Loading...
