Safety
17
Pos: 16.9.31 /BA/Si cherheit/1. Grundlegend e Sicherheitshin weiseGefahrenberei ch zwischen Traktor und Ma schine_Wender-Sc hwader_RP_LW_BP_Mäh werke @ 453\mod_14640018779 43_78.docx @ 3078893 @ @ 1
Danger zone between tractor and machine
People standing between the tractor and machine may be seriously injured or killed if the tractor
rolls away or by carelessness or machine movements:
• Before working between tractor and machine: Shutdown and safeguard the machine, refer
to chapter Safety “Shutting Down and Safeguarding the Machine”. This also applies to brief
inspection work.
• If the power lifter has to be actuated, keep all people away from the range of movement of
the power lifter.
Pos: 16.9.32 /BA/Si cherheit/1. Grundlegend e Sicherheitshin weiseGefahrenberei ch bei eingeschaltet em Antrieb_fuer alle @ 453\ mod_1463995368453_78. docx @ 3078086 @ @ 1
Danger zone when drive is switched on
When the drive is switched on, there is a danger to life caused by rotating machine parts. There
must be nobody in the danger zone of the machine.
• Before starting the machine, direct all people out of the danger zone of the machine.
• If hazardous situations arise, switch off drives immediately and instruct people to leave the
danger zone.
Pos: 16.9.33 /BA/Si cherheit/1. Grundlegend e Sicherheitshin weiseGefahrenberei ch Zapfwelle_fuer al le @ 453\mod_14639936890 07_78.docx @ 3077933 @ @ 1
Danger zone PTO shaft
People may be caught, pulled in and seriously injured by the PTO shaft and the driven
components.
Before switching on the PTO shaft:
• Make sure that all safety devices are fitted and in the protection position.
• Ensure that there is nobody in the danger zone of PTO shaft and universal shaft.
• Switch off the drives if they are not necessary.
Pos: 16.9.34 /BA/Si cherheit/1. Grundlegend e Sicherheitshin weiseGefahrenberei ch Gelenkwelle_fuer alle @ 453\mod_146399307 5614_78.docx @ 3077842 @ @ 1
Danger zone universal shaft
People may become caught by the universal shaft, pulled in and seriously injured.
• Observe the operating instructions of the universal shaft.
• Provide the section tube and universal shaft guards with adequate cover.
• Allow the universal shaft locks to engage.
• Attach the chains to prevent the universal shaft guards from rotating with the shaft.
• Ensure that there is nobody in the danger zone of PTO shaft and universal shaft.
• Make sure that the universal shaft guards are attached and functional.
• If the angles between universal shaft and PTO shaft are too large, switch off the PTO shaft.
The machine may be damaged. Parts could be hurled up and hurt people.
Pos: 16.9.35 /BA/Si cherheit/1. Grundlegend e Sicherheitshin weise/Gefahrenberei ch Nachlaufende Masc hinenteile - KW/T 10.02, KWT 1600, div Schwader @ 276\mod_14 04743505456_78.doc x @ 2074851 @ @ 1
Danger zone due to coasting machine parts
When the drives have been switched off, the following machine parts will coast:
– Universal shaft
– Rotor
When machine parts are coasting, people may be seriously injured or killed.
Shut down and safeguard the machine, see chapter Safety, "Shutting down and safeguarding
the machine".
• Do not touch machine parts until they have come to a standstill.
Pos: 16.9.36 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.d ocx @ 4165 @ @ 1
To Next Page
Loading...
