MAINTENANCE WORK ON CHASSIS AND ENGINE 148
9.54Mounting the helmet lock on the vehicle
Warning
Danger of accidents Impairment of handling characteristics and vehicle operation by a fitted helmet lock or helmet.
– Do not use the helmet lock for holding a helmet or other objects during the journey. Always remove the helmet lock before start-
ing out.
700336-01
– Remove the seat. ( p. 146)
– Position the steel cable from the toolset with one loop on the lug .
Steel cable (60012015000)
– Guide the steel cable through the helmet opening.
– Then position the free loop of the steel cable on the lug.
– Position the helmet carefully on the side of the motorcycle.
– Fit the seat. ( p. 146)
9.55Removing the battery x
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
– Keep batteries out of the reach of children.
– Wear suitable protective clothing and goggles.
– Avoid contact with battery acid and battery gases.
– Keep the battery away from sparks or open fire. Charge only in well-ventilated rooms.
– In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least 15
minutes and contact a physician.
To Next Page