11 SERVICE WORK ON THE CHASSIS 159
11.7 Fitting the seat
B01323-10
– Position the recesses of the seat to the lugs on the frame, lower the rear end and simul-
taneously push it forward.
– Lock the seat by turning the ignition key in the seat lock.
– Remove the ignition key from the seat lock.
– Finally, check that the seat is correctly mounted.
11.8 Mounting the helmet lock on the vehicle
Warning
Danger of accidents Impairment of ride behavior and vehicle operation if a helmet or helmet lock is attached to the vehicle.
– Do not use the helmet lock for holding a helmet or other objects during the journey. Always remove the helmet lock before start-
ing out.
B01324-10
– Remove the seat. ( p. 158)
– Position the steel cable from the tool kit with one loop on the lug 1.
Steel cable (60012015000)
– Guide the steel cable through the helmet opening.
– Then position the free loop of the steel cable on the lug.
– Position the helmet carefully on the side of the vehicle.
– Fit the seat. ( p. 159)
To Next Page
Loading...
