KTM 2013 1190 RC8 R EU/UK - Adjusting the Shift Speed RPM1;2

6 CONTROLS 87
– Press the MODE button briefly.
The settings are stored and the display changes to the SET‑UP menu.
– Press the button briefly and repeatedly until the symbol shows EXIT SETUP in the
info display.
– Press the MODE button briefly.
6.11.50 Adjusting the shift speed RPM1/2
Condition
The ignition is on.
The motorcycle is stationary.
400460-01
– Press the button and the button for 3 - 5 seconds.
– Press the button twice until the symbol shows SETTINGS in the info display.
– Press the MODE button briefly.
– Press the MODE button briefly.
RPM1 and RPM2 appear on the info display.
The engine speed after RPM1 flashes.
Info
The engine speed can be set at intervals of 50.
RPM1 is the engine speed above which the shift warning light starts to flash.
– Set the engine speed with the button or the button .
– Press the MODE button briefly.
The engine speed after RPM2 flashes.