6 CONTROLS 88
Info
RPM2 is the engine speed above which the shift warning light lights up con-
stantly. If RPM1 = RPM2, the shift warning light lights up constantly when you
reach the engine speed set.
– Set the engine speed with the button or the button .
– Press the MODE button briefly.
The settings are stored and the display switches to the SETTINGS menu.
Info
At delivery, RPM1 is set to 10000 and RPM2 to 10500.
– Press the button briefly and repeatedly until the symbol shows BACK... in the info
display.
– Press the MODE button briefly.
– Press the button briefly and repeatedly until the symbol shows EXIT SETUP in the
info display.
– Press the MODE button briefly.
6.11.51 Setting the blank time of the LAP button LAP BLANK TIME
Condition
The ignition is on.
The motorcycle is stationary.
To Next Page
Loading...
