To Next PageTo Next Page
Need help?Do you have a question about the KYMCO Mongoose/KXR 250 and is the answer not in the manual?
General| Brand | KYMCO |
|---|---|
| Model | Mongoose/KXR 250 |
| Category | Offroad Vehicle |
| Language | English |
Details technical specifications for the engine, fuel system, electrical components, and chassis.
Provides essential safety guidelines and procedures for maintenance and repair.
Lists specific torque specifications for important fasteners to ensure correct assembly.
Identifies specialized tools required for specific maintenance and repair procedures.
Provides a schematic diagram of the ATV's electrical system for off-road configuration.
Provides a schematic diagram of the ATV's electrical system for on-road configuration.
Offers diagnostic procedures and solutions for common engine starting and performance issues.
Outlines the steps for safely removing and installing the exhaust muffler, including torque specifications.
Provides a recommended schedule for routine inspections and maintenance tasks.
Explains how to inspect and adjust valve clearance and set the carburetor idle speed.
Covers procedures for checking ignition timing and measuring cylinder compression.
Details how to check the engine oil level and perform oil and filter changes.
Covers inspection of the drive belt, brake pads, and brake fluid levels.
Explains how to check and adjust the drive chain slack.
Covers engine oil/filter checks and the removal procedure for the oil pump assembly.
Details the disassembly, inspection, and assembly process for the oil pump.
Covers the disassembly, cleaning, and inspection of the fuel valve components.
Explains the process for disassembling the throttle valve assembly.
Details the removal procedure for the carburetor, including draining fuel and disconnecting cables.
Covers the disassembly of the carburetor, including float chamber and jet holder removal.
Explains carburetor cleaning procedures and inspection of the float and float valve.
Details the assembly of the carburetor and how to inspect and adjust the float level.
Step-by-step instructions for removing the engine, including disconnecting various hoses and wires.
Final steps for engine removal, involving mounting bolts and engine brackets.
Specifies torque values for cylinder head components and lists required special tools.
Explains how to remove the camshaft and camshaft holder assembly.
Covers inspection of the camshaft holder and rocker arm shafts for wear and damage.
Provides steps for removing the cylinder head, including associated components.
Details the procedure for disassembling the cylinder head, including valve components.
Explains how to inspect valves and guides for wear, damage, and proper clearance.
Covers checking the cylinder head for cracks and warpage.
Step-by-step guide for assembling the cylinder head components.
Details the procedure for removing the cylinder and piston assembly.
Covers inspection of the piston, rings, and ring-to-groove clearance.
Instructions for installing piston rings onto the piston, including proper orientation.
Explains the procedure for draining and refilling the front brake fluid and bleeding air.
Outlines the process for bleeding air from the brake system to ensure proper function.
Lists common starting system problems like starter motor not turning or engine not starting.
