Name: KYMCO SUPER8 50 2T
Brand: KYMCO
Rating: 4 (1 reviews)

To Next Page

To Previous Page

11. CARBURETOR

11-10

SUPER8 50 2T

FLOAT CHAMBER ASSEMBLY

Install the main jet and needle jet holder.

Install the air screw and throttle stop screw

according to the rotations recorded.

Install the float valve, float and float pin.

Tighten the float screw securely.

FLOAT LEVEL INSPECTION

Slightly tilt the carburetor and measure the

float level with the float valve just

connecting the float arm.

Float Level: 8.6mm

Replace the float if the level is out of the

specified level range.

Install the O-ring.

Check the operation of the float and install

the float chamber.

Tighten the screws.

If the air screw must be replaced, be

sure to perform the air screw

adjustment again.

＊

ir Screw

Throttle Stop Screw

Needle Jet holde

Float Pin

Main Jet

Slow Jet

Questions and Answers:

Need help?

Do you have a question about the KYMCO SUPER8 50 2T and is the answer not in the manual?

KYMCO SUPER8 50 2T Specifications

General