EasyManuals Logo

KYMCO SUPER8 50 2T User Manual

KYMCO SUPER8 50 2T
188 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #150 background imageLoading...
Page #150 background image
13.STEERING HANDLEBAR/FRONT WHEEL/FRONT BRAKE/FRONT SHOCK
ABSORBER/FRONT FORK
13-14
SUPER8 50 2T
INSPECTION
Inspect the following items and replace if
necessary.
Front shock absorber tube bending or
damage.
Weak front shock absorber spring.
Damper and damper rod bending.
Oil seal damage or wear.
INSTALLATION
Install the front shock absorbers onto the
steering stem.
Install and tighten the front shock absorber
upper mount bolts.
Tighten the lower mount bolts.
Install the front wheel.
STEERING HANDLEBAR
REMOVAL
Remove the handlebar covers. (
Ö
2)
Remove the rear brake lever holder bolt to
remove the holder.
Remove the front brake master cylinder
holder bolts to remove the brake master
cylinder.
Mount Boot
Brake Master C
y
linde
r
Bolts
Align the upper mount bolt hole with the
groove on the front fork.
Front shock absorbers are installed at
the same altitude.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KYMCO SUPER8 50 2T and is the answer not in the manual?

KYMCO SUPER8 50 2T Specifications

General IconGeneral
Engine Type2-stroke, single cylinder
Fuel SystemCarburetor
TransmissionCVT automatic
Front SuspensionTelescopic fork
Rear SuspensionSingle Shock
Front BrakeDisc
Rear BrakeDrum
Front Tire120/70-12
Rear Tire130/70-12
Seat Height780 mm
IgnitionCDI
StarterElectric & Kick
Width700 mm
Cooling SystemAir-cooled

Related product manuals