Name: KYMCO SUPER8 50 2T
Brand: KYMCO
Rating: 4 (1 reviews)

To Next Page

To Previous Page

13.STEERING HANDLEBAR/FRONT WHEEL/FRONT BRAKE/FRONT SHOCK

ABSORBER/FRONT FORK

13-5

SUPER8 50 2T

FRONT WHEEL BEARING

Remove the side collar and dust seal.

Turn the inner race of each bearing with your

finger to see if they turn smoothly and quietly.

Also check if the outer race fits tightly in the

hub.

Replace the bearings if the races do not turn

smoothly, quietly, or if they fit loosely in the

hub.

BEARING REPLACEMENT

Remove the front wheel bearings and

distance collar.

Bearing Remover

Bearing Remover Head, 12mm

Pack all bearing cavities with grease.

Drive in the left bearing.

Install the distance collar.

Drive in the right bearing.

Driver handle A

• Do not allow the bearings to tilt while

driving them in.

• Drive in the bearing squarely with the

sealed end facing out.

＊

Wheel Bearin

Special

Dust Seal

Bearing Remove

Driver Handle

Side Colla

Questions and Answers:

Need help?

Do you have a question about the KYMCO SUPER8 50 2T and is the answer not in the manual?

KYMCO SUPER8 50 2T Specifications

General