KYMCO SUPER8 50 2T User Manual

17. EXHAUST EMISSION CONTROL
SYSTEM
17-4
SUPER8 50 2T
REED VALVE
REMOVAL
Disconnect the secondary air inlet tube
connector.
Remove the reed valve cover three bolts.
Remove the three bolts attaching the reed
valve cover and the reed valve.
INSPECTION
Check the reed valve for cracks, damage,
big clearance or weak reeds. Replace if
necessary.
Check the gasket and O-ring for damage or
deterioration and replace if necessary.
Reed valve stopper clearance: 4.6mm
INSTALLATION
Install the reed valve in the reverse order of
removal.
Secondary Air Inlet Tube Clip
Reed Valve
Reed Sto
pp
e
r
Reed Valve Cover Bolt
• When installing, be careful not to bend
or twist the tubes and check for prope
r
installation.
＊

KYMCO SUPER8 50 2T Specifications

General

Engine Type	2-stroke, single cylinder
Fuel System	Carburetor
Transmission	CVT automatic
Front Suspension	Telescopic fork
Rear Suspension	Single Shock
Front Brake	Disc
Rear Brake	Drum
Front Tire	120/70-12
Rear Tire	130/70-12
Seat Height	780 mm
Ignition	CDI
Starter	Electric & Kick
Width	700 mm
Cooling System	Air-cooled