Name: KYMCO SUPER8 50 2T
Brand: KYMCO
Rating: 4 (1 reviews)

To Next Page

To Previous Page

15. ELECTRICAL EQUIPMENT

15-9

SUPER8 50 2T

Performance Test

Remove the ignition coil.

Inspect the ignition coil with an ignition coil

tester.

1. Turn the changeover switch to 12V and

connect the ignition coil to the tester.

2. Turn the power switch ON and check the

spark from the watch window.

‧Good : Normal and continuous spark

‧Faulty: Weak or intermittent spark

A.C. GENERATOR

Exciter Coil/Pulser Coil Inspection

Remove the met-in box. (

12-4)

Disconnect the A.C. generator wire

connector.

Measure the pulser coil resistance between

the blue/yellow wire and ground.

Resistance (20℃): 100～150Ω

This test is performed with the stator

installed in the engine.

＊

Follow the ignition coil tester manufac-

turer‘s instructions.

＊

Ignition Coil

The test is performed at both conditions

that the ignition coil is cold and hot.

＊

Questions and Answers:

Need help?

Do you have a question about the KYMCO SUPER8 50 2T and is the answer not in the manual?

KYMCO SUPER8 50 2T Specifications

General