Name: KYMCO SUPER8 50 2T
Brand: KYMCO
Rating: 4 (1 reviews)

To Next Page

To Previous Page

8. KICK STARTER/DRIVE PULLEY/

CLUTCH/DRIVEN PULLEY

8-11

SUPER8 50 2T

Install the drive belt on the crankshaft.

Install the drive face, starting ratchet and

washer, then tighten the 12mm drive face

nut.

Torque: 3.5～4.0kg-m

STARTER PINION

REMOVAL

Remove the left crankcase cover. (

8-4)

Remove the drive pulley. (

8-8)

Remove the starter pinion.

INSPECTION

Inspect the starter pinion seat for wear.

Inspect the starter pinion for smooth

operation.

Inspect the starter pinion shaft forcing parts

for wear and damage.

INSTALLATION

Apply a small amount of grease to the

starter pinion teeth.

Install the starter pinion in the reverse order

of removal.

Keep grease or oil off the drive belt and

drive pulley faces.

＊

Drive Face Nut

Starting Ratchet

Drive Pulley Face

Starter Pinion

Shaft Forcing Parts

Starter Pinion

Questions and Answers:

Need help?

Do you have a question about the KYMCO SUPER8 50 2T and is the answer not in the manual?

KYMCO SUPER8 50 2T Specifications

General