KYMCO SUPER8 50 2T User Manual

16. INSTRUMENT/SWITCHES/LIGHTS
16-8
SUPER8 50 2T
INSTRUMENTS
BULB REPLACEMENT
Remove the handlebar rear cover. (
Ö
2)
Remove the bulb socket and replace the
bulb.
The installation sequence is the reverse of
removal.
INSTRUMENTS REPLACEMENT
Remove the handlebar rear cover. (
Ö
2)
Disconnect the right and left handlebar
switches wire couplers.
Disconnect the speedometer cable.
Remove the instrument bulb sockets
Disconnect the two fuel gauge wires.
Remove the instrument wire clamp screw.
Remove the three screws attaching the
instruments to the handlebar rear cover.
Remove the instruments.
HEADLIGHT
REMOVAL/BULB REPLACEMENT
Remove the handlebar rear cover. (
Ö
2)
Remove the bulb sockets and bulbs.
The installation sequence is the reverse of
removal.
Bolts
Bulb Sockets
Bulb Socket
• The model adopts krypton gas bulb.
When installing, do not directly touch
the bulb glass with fingers.
• Use bulbs of the same specifications
for replacement.
＊

KYMCO SUPER8 50 2T Specifications

General

Engine Type	2-stroke, single cylinder
Fuel System	Carburetor
Transmission	CVT automatic
Front Suspension	Telescopic fork
Rear Suspension	Single Shock
Front Brake	Disc
Rear Brake	Drum
Front Tire	120/70-12
Rear Tire	130/70-12
Seat Height	780 mm
Ignition	CDI
Starter	Electric & Kick
Width	700 mm
Cooling System	Air-cooled