KYMCO SUPER8 50 2T User Manual

2 . GENERAL INFORMATION
2-22
SUPER8 50 2T
ENGINE STOPS IMMEDIATELY AFTER IT STARTS
c Empty fuel tank
d Clogged float valve
e Clogged charcoal canister
f Clogged fuel filter
g Faulty auto fuel valve
c Fouled spark plug
d Incorrect heat range plug
c Fouled spark plug
d Faulty CDI unit
e Faulty A.C. generator
f Faulty ignition coil
g Broken or shorted high
tension wire
h Faulty ignition switch
c Worn cylinder and piston
rings
d Blown cylinder head gasket
e Flaws in cylinder head
f Faulty reed valve
g Seized piston
c Clogged carburetor jets
c Faulty CDI unit or A.C.
generator
d A.C.G. flywheel not aligned
c Mixture too rich (turn screw
out)
d Mixture too lean (turn
screw in)
Check if fuel reaches
carburetor by
loosening drain
screw.
Inspection/Adjustment Symptom
Probable Cause
Fuel reaches
carburetor
Good spark
Remove spark plug
and install it into
spark plug cap to test
spark by connecting it
to engine ground.
Correct timing
Correctly adjusted
Plug not fouled o
r
discolored
Normal
compression
Not Clogged
Fuel does not
reach carburetor
Weak or inter-
mittent spark
Incorrect timing
Incorrectly adjusted
Plug fouled o
r
discolored
Abnormal
compression
Clogged
Test cylinde
r
compression (using a
compression gauge).
Check carburetor fo
r
clogging.
Check ignition timing.
Check carburetor ai
r
screw adjustment.
Remove spark plug
and install it into
spark plug cap to test
spark by connecting it
to engine ground.

KYMCO SUPER8 50 2T Specifications

General

Engine Type	2-stroke, single cylinder
Fuel System	Carburetor
Transmission	CVT automatic
Front Suspension	Telescopic fork
Rear Suspension	Single Shock
Front Brake	Disc
Rear Brake	Drum
Front Tire	120/70-12
Rear Tire	130/70-12
Seat Height	780 mm
Ignition	CDI
Starter	Electric & Kick
Width	700 mm
Cooling System	Air-cooled