Kyocera FS-1018MFP

Legal and Safety Information
x BASIC OPERATION GUIDE
Installation Precautions
Environment
CAUTION: Avoid placing the machine on or in locations
which are unstable or not level. Such locations may cause the
machine to fall down or fall over. This type of situation presents
a danger of personal injury or damage to the machine.
Avoid locations with humidity or dust and dirt. If dust or dirt
become attached to the power plug, clean the plug to avoid the
danger of fire or electrical shock.
Avoid locations near radiators, heaters, or other heat sources, or
locations near flammable items, to avoid the danger of fire.
To keep the machine cool and facilitate changing of parts and
maintenance, allow access space as shown below. Leave
adequate space, especially around the vents, to allow air to be
properly ventilated out of the machine.
Other Precautions
Adverse environmental conditions may affect the safe operation and
performance of the machine. Install in an air-conditioned room
(recommended room temperature: around 68 °F (20 °C), humidity: around
65 %), and avoid the following locations when selecting a site for the
machine.
• Avoid locations near a window or with exposure to direct sunlight.
• Avoid locations with vibrations.
• Avoid locations with drastic temperature fluctuations.
• Avoid locations with direct exposure to hot or cold air.
• Avoid poorly ventilated locations.
Left:
11
13/16"
30 cm
Front:
39
3/8"
100 cm
Right:
11
13/16"
30 cm
Rear:
11
13/16"
30 cm