Kyocera FS-1018MFP

Preparation
BASIC OPERATION GUIDE 3-13
Subnet Mask Setting
Continue from the previous Step 8 to register the Subnet Mask address.
NOTE: If you are not sure of the appropriate Subnet Mask address,
contact your Network Administrator.
1
Access the TCP/IP Settings screen.
2
Press  or  to select Subnet
Mask and press [Enter].
The Subnet Mask screen
displays.
3
Enter the Subnet Mask address using the same procedure used for the IP
Address in steps 6 through 8 of IP Address Setting.
Registering the Default Gateway
Use the following procedure to register the Default Gateway address. If
you are not sure of the appropriate Default Gateway address, contact your
Network Administrator.
1
Access the TCP/IP Setting screen.
2
Press  or  to select Default
Gateway and press [Enter].
The Default Gateway screen
displays.
3
Enter the Default Gateway address using the same procedure used for the
IP Address in steps 6 through 8 of IP Address Setting.
TCP/IP Setting:
DHCP
IP Address
Exit
Subnet Mask
*
TCP/IP Setting:
IP Address
Subnet Mask
Exit
Default Gateway