Kyocera FS-1018MFP

Preparation
3-20 BASIC OPERATION GUIDE
Available Characters
The following three character entry modes are available. Press the right
[Select] key to switch between character types.
Character Assignments
The following characters can be entered using the keypad. Each time a key
is pressed the character changes. For example, press key 1 twice to enter
the character @. Use  or another key to register each character after
entry. This procedure is repeated until all the characters are entered.
Mode Available characters
Alphabetic/Symbol
Text ABC
Refer to the list of character assignments below.
Numeric
Text 123
Symbol
Text Symbols
! ” #$%&’ ( )
*+,-./:;<=
>?@[\]^_`{
|}~
Key Entry mode Available characters
Alphabetic/Symbol . @ - _ / : ~ 1
Numeric 1
Alphabetic/Symbol a b c A B C 2
Numeric 2
Alphabetic/Symbol d e f D E F 3
Numeric 3
Alphabetic/Symbol g h i G H I 4
Numeric 4
Alphabetic/Symbol j k l J K L 5
Numeric 5
Alphabetic/Symbol m n o M N O 6
Numeric 6
Alphabetic/Symbol p q r s P Q R S 7
Numeric 7