Optional Equipment
BASIC OPERATION GUIDE 5-3
Document Processor
Automatically feeds and scans
multiple originals one by one.
Acceptable Originals
• Use sheet originals only
• Paper weight: 50 to 120 g/m²
• Paper sizes: 8.5 x 14"/Legal and Folio (Maximum), 5.5 × 8.5"/
Statement and A5R (Minimum)
• Maximum capacity: 50 sheets (50 to 80 g/m²) at one time.
Notes on Acceptable Documents
Do not use the following originals in the Document Processor. In addition,
originals with punched holes or perforations should be loaded with the hole
punched or perforated edge facing away from the direction of insertion into
the Document Processor.
• OHP and other transparency films.
• Soft originals, for example carbon or vinyl paper, or other originals that
are curled, wrinkled or creased.
• Irregularly shaped originals, wet originals, or originals that contain
adhesive tape or glue.
• Originals bound with clips or staples. If using these originals, to avoid
jams remove the clips or staples and straighten any curls, wrinkles or
creases, before loading in the Document Processor.
• Originals with cut-out sections or that have a slippery surface on either
side.
• Originals on which any correction fluid is still wet.
• Originals with strong folds. If using these originals, smooth out the
folds before loading in the Document Processor. Failure to do so may
result in the originals becoming jammed.
IMPORTANT: Ensure the Document Processor is closed whenever
transporting the machine.
To Next Page
Loading...
