Basic Operation
BASIC OPERATION GUIDE 4-17
Low Power Mode
Low Power mode automatically
puts the machine into an energy-
saving state if no operation has
been performed for a preset
period of time (between 1 minute
and 240 minutes). The factory
default setting is 5 minutes.
The message display shows Low
Power Mode, and nothing is
shown on the Operation Panel.
To enable copying or scanning, press any key on the Operation Panel. If
the optional Document Processor is installed, copying will be enabled
automatically when an original is loaded in the Document Processor.
NOTE: It is possible to set the amount of time before Low Power mode
engages. For details, refer to the Advanced Operation Guide.
When Low Power mode is engaged, the optical lamp will be dimly lit.
*
Low power
To Next Page
Loading...
