Optional Equipment
BASIC OPERATION GUIDE 5-7
Expansion Memory
It is possible to increase the
memory in your machine. Adding
additional memory will increase
the number of originals that can
be scanned at one time. An
additional 64 MB, 128 MB, or
256 MB is effective when copying
from originals with photos, due to
their normally low compression
ratio.
To expand memory up to 320 MB, remove the 32 MB memory module that
is installed at the factory and install a 256 MB memory module.
IMPORTANT: The expansion memory should only be installed by your
dealer. We shall not be liable for any damages caused by improper
installation of expansion memory.
Installing the DIMM (Dual Inline Memory Module)
Contact your dealer for information about purchasing a DIMM which is
suitable for use with this printer. Insert the DIMM into the socket as follows:
1
Switch off the machine and disconnect the power cord and machine cable.
2
Remove the screw from the rear
of the machine and remove the
side cover.
3
Remove the DIMM by carefully
pulling the end stoppers outwards,
then pulling the DIMM out of the
socket.
4
Insert the replacement DIMM into the DIMM socket so that the notches on
the DIMM align with the corresponding protrusions in the slot.
When you have finished installing the DIMM, replace the side cover and
fasten it with the screw.
To Next Page
Loading...
