Kyocera FS-1018MFP

Preparation
BASIC OPERATION GUIDE 3-11
Network Settings
IP Address Setting
Use the following procedure to register the IP Address.
NOTE: The IP Address could differ depending on your network
environment. Check with your Network Administrator before programming
this setting. Any changes made to the network settings will become valid
after you power the machine off then on.
If you use the following procedure to register the IP Address manually,
ensure the DHCP setting is Off and the TCP/IP setting is On, refer to
Chapter 3, Advanced Operation Guide for details.
1
Press [System Menu / Counter]. The System Menu/Count screen
displays.
2
Press  or  to select System
Setting and press [Enter].
The System Setting screen
displays.
3
Press  or  to select Network
Setting and press [Enter].
The Network Setting screen
displays.
4
Press  or  to select TCP/IP
Setting and press [Enter].
The TCP/IP Setting screen
displays.
*
Sys. Menu/Count.:
Counter
System Setting
Report
Exit
*
System Setting:
Back
Network Setting
Parallel Setting
Exit
*
TCP/IP Setting:
Back
TCP/IP
DHCP
Exit
*
Network Setting:
Back
AppleTalk Set.
TCP/IP Setting
Exit