Machine Parts
2-4 BASIC OPERATION GUIDE
20 Document Processor Connector — Attach the connection cable to
install the optional Document Processor.
21 Parallel Interface Connector — Use a parallel cable to connect to
the parallel port of your computer.
22 USB Interface Connector — Conforms to Hi-Speed USB2.0. Use a
USB cable to connect with a USB port on your computer.
23 Right Cover Anchor Pin — Remove this pin and open the right
cover to access the additional memory slot. To add additional
memory, contact your Service Representative or an Authorized
Service Center.
24 Network Interface Connector — Use a 10Base-T/100Base-TX
network cable to connect the machine to a network.
25 Rear Cover (Face-up Tray) — When open, it is used as the Face-up
Tray. Finished copies or prints can be output face up to this tray.
26 Power Switch — Press to on ( | ) to power on the machine.
27 Power Cord
26
24
27
20
23
21
22
25
To Next Page
Loading...
