Preparation
BASIC OPERATION GUIDE 3-3
2
Adjust the Paper Stopper located
at the rear of the cassette by
pressing the release buttons and
sliding the stopper to fit the size of
the paper being loaded. The
paper sizes are marked on the
base of the cassette - the factory
default setting is A4/Letter.
NOTE: For information on adjusting the Paper Stopper for Folio or
Oficio II size paper, refer to page 3-4.
3
Adjust the paper width guides on
both sides of the cassette by
pressing the release buttons and
sliding the guides to fit the width of
the paper - the factory default
setting is for A4/Letter.
4
Load the paper in the cassette,
the leading edge must be aligned
against the Paper Stopper.
Ensure the paper doesn’t catch
on the overhanging tabs.
IMPORTANT: Always adjust the
paper stopper and paper width
guides before loading paper to
avoid skewed paper feed and/or a
paper jam.
Ensure the paper is placed
securely against the paper
stopper and the paper width
guides with no gap.
Ensure the side to be printed is
facing downward and the paper is not folded, curled, or damaged.
Do not load paper above the fill lines located on the width guides.
To Next Page
Loading...
