Kyocera KM-2560

2H0/2HZ
1-3-90
LF action
Set the line feed action when the machine receives the
line feed code.
1. Press the cursor down key and [Change] of
LF Action.
2. Select [LF Only], [LF and CR] or [Ignore LF].
3. Press [OK].
CR action
Set the character return action when the machine
receives the character return code.
1. Press the cursor down key and [Change] of
CR Action.
2. Select [CR Only], [LF and CR] or [Ignore CR].
3. Press [OK].
(7) Network setup
TCP/IP setup by entering IP addresses
Set up TCP/IP to connect to the Windows network. Set
the IP addresses, subnet masks, and gateway
addresses.
1. Press [Next] of Network and then [Change] of
TCP/IP.
2. Press [On] on the left side of the touch panel.
3. Press [Off] of DHCP.
4. Press [IP Address] and enter the address using the
numeric keys.
5. Press [Subnet Mask] and enter the address using
the numeric keys.
6. Press [Default Gateway] and enter the address
using the numeric keys.
7. Check if all the address entries are correct and
press [OK].
8. Press the power key and confirm that the power
key/indicator and the memory indicator are off.
After that, turn the main power switch off and on.
TCP/IP setup (Equipped with DHCP server)
Set up TCP/IP when the network is equipped with the
DHCP server.
1. Press [Next] of Network and then [Change] of
TCP/IP.
2. Press [On] on the left side of the touch panel.
3. Press [On] of DHCP.
4. Press [OK].
5. Press the power key and confirm that the power
key/indicator and the memory indicator are off.
After that, turn the main power switch off and on.
Netware setup
Select the NetWare network connection.
1. Press [Next] of Network and then [Change] of
NetWare.
2. Press [On].
3. Select the frame type.
4. Press [OK].
5. Press the power key and confirm that the power
key/indicator and the memory indicator are off.
After that, turn the main power switch off and on.
AppleTalk setup
1. Press [Next] of Network and then [Change] of
Apple Talk.
2. Press [On].
3. Press [OK].
4. Press the power key and confirm that the power
key/indicator and the memory indicator are off.
After that, turn the main power switch off and on.