2H0/2HZ
1-3-3
High voltage U100 Setting the main high voltage -
U101
Setting the other high voltages
26/58/50/89/1
*1
115/91/68/40/92
*1
U110 Checking the drum count -
U114
Setting separation charger mode
4
*1
U117 Checking the drum number -
U118 Displaying the drum history -
Developing U130 Initial setting for the developing unit -
U135 Checking toner motor operation 100/30/100
*1
U144 Setting toner loading operation 0/5/30
*1
U150 Checking sensors for toner -
U157 Checking/clearing the developing drive time -
U158 Checking the developing count -
Fuser and
cleaning
U161 Setting the fuser control temperature
Driving start temperature when warm-up starts
Fuser center control temperature for displaying
[Ready for copying.]
Fuser edge control temperature for displaying
[Ready for copying.]
Fuser center control temperature during printing
Time of period from driving until Ready is displayed
110
*1
165
*1
155
*1
165
*1
0
*1
U163 Resetting the fuser problem data -
U167 Checking/clearing the fuser counts -
U193 Setting the fuser drive control ON
*1
U199 Checking the fuser temperature -
Operation
panel and
support
equipment
U200 Turning all LEDs on -
U201 Initializing the touch panel -
U202 Setting the KMAS host monitoring system -
U203 Checking DP operation -
U204 Setting the presence or absence of a key card or key counter OFF/COUNTER
*1,*2
U207 Checking the operation panel keys -
U220 Setting the trial functions -
U221 Setting the USB host lock function OFF
*1
U233 Limiting job separator output MODE0
*1,*2
U236 Setting the limit for the ejection section of the built-in finisher OFF
*1,*2
U243 Checking the operation of the DP motors -
U244 Checking the DP switches -
U245 Checking messages -
U246 Setting the finisher 0/0/0
*1
U247 Setting the paper feed device -
Mode setting U250 Setting the maintenance cycle 300000
*1,*2
U251 Checking/clearing the maintenance count -
U252 Setting the destination -
U253 Switching between double and single counts Double count (A3/LGR)
*1
U260 Selecting the timing for copy counting After ejection
*1,*2
U265 Setting OEM purchaser code 0
*1
U285 Setting service status page ON
*1,*2
Section Item
No.
Content of maintenance item Initial
setting*
*Initial setting for executing U020, *1: The item initialized for executing U020, *2: The item initialized for executing U021
To Next Page
Loading...
