ENDB
91
ENDB — END a two-dimensional Barcode string
Format
ENDB;
Parameter
None
Function
The ENDB command terminates a barcode data string preceded by a XBAR or XBUF
command. If there is no ENDB command after data input for the XBAR and XBUF
commands, a malfunction may occur. As in the case of XBAR or XBUF command, if
data length is omitted, 0, negative value or non integer, data string is counted, all
characters until the program sees ;ENDB;. It is necessary to have no space and line feed
between ‘;’ and ENDB.
If the XBCP 18 command is executed, the second and subsequent macro PDF417
symbols will be output. When ENDB is used immediately after XBCP 18 is executed, it
is used alone, without association with XBAR or XBUF.
For details on two-dimensional barcodes, see Section 5.2. of the Technical Reference
manual.
To Next Page
Loading...
Need help?
General
