PRESCRIBE Command Reference
146
LAPI — LoaD API Program
Format
LAPI Program type, PRESCRIBE command, function name;
Parameters
Program type:
Type of the downloading program
"PRE" PRESCRIBE command
PRESCRIBE command name:
Name of the PRESCRIBE command to be stored
Alphanumeric string of 2 to 4 characters
(Only in the case of "PRE")
Function name:
Name of the function that starts the user program
(Only in the case of "PRE")
Up to 31 characters
Function
The LAPI command downloads the API program.
As described in the example below, add the string "WRED" to the end of the
downloading data as a terminator.
It is possible to add a string other than "WRED." It is because if the downloading
program includes the string "WRED," this must be changed. To change the terminator,
use the RWRF T command.
When storing a new PRESCRIBE command, if the specified command name has already
been stored, the sending data will be invalid.
Data downloaded with the LAPI command will be deleted (invalid) upon the system
restart.
Example:
!R! LAPI "PRE" , "XXXX" , "XXXXXXXX" ;[Program Data]WRED;
EXIT;
After "WRED" is changed to "TEST"
!R! LAPI "PRE" , "XXXX" , "XXXXXXXX" ;[Program Data]TEST;
EXIT;
To Next Page
Loading...
Need help?
General
