ACLI — Add CoLor by Index
Format
ACLI index, color1, color2, color3;
Parameters
index:
integer from 1 to 255
color1:
value for red, integer from 0 to 255, in RGB color space
value for lightness, number from 0.0 to 100.0, in L*a*b color space
color2:
value for green, integer from 0 to 255, in RGB color space
value for red/green, number from 0.0 to
100.0, in L*a*b color space
color3:
value for blue, integer from 0 to 255, in RGB color space
value for yellow/blue, number from 0.0 to 100.0, in L*a*b color space
Function
The ACLI command adds a color to the currently active palette. This command is
ignored when the currently active palette is a simple color palette or the Pantone color
palette. If an index number larger than the palette size is given, this command is also
ignored. If a color is added to the existing index number, the current color for that index
number is automatically replaced with the new color.
To add a color in a palette, the following guidelines must be used depending on the color
space used:
For RGB color space, specify the values for red, green, and blue with an integer from 0
to 255, where 0 = 0% and 255 = 100%. Any value outside this range is rounded to the
minimum or maximum value, namely 0 or 255. A fractional value beyond the decimal
point is discarded.
For L*a*b color space, specify relative values for the lightness, red/green, and yellow/
blue with a number from 0.0 to 100.0. Any value outside this range is rounded to the
minimum or maximum value, namely 0.0 or 100.0.
To Next Page
Loading...
Need help?
General
