To Next Page

To Previous Page

PRESCRIBE Command Reference

312

SLS — Set Line Spacing

Format

SLS distance;

Parameter

distance:

Line-to-line spacing

Function

The SLS command sets the distance from the base of one line to the base of the next line.

The distance is measured in the unit value designated by the UNIT command.

The line spacing can be set by either the SLS or the SLPI (set lines per inch) command.

SLPI sets the number of lines per inch. SLS sets the number of inches (or other units) per

line.

File

!R! RES; UNIT C; STM 5;

SFNT "TimesNewRoman";

EXIT;

These lines have the

default line spacing

of 0.423 cm (6 lpi).

!R! SLS .6; EXIT;

These lines are

spaced at intervals

of .6 centimeters.

!R! PAGE; EXIT;

Printout

Related Command

SLPI

Kyocera KM-C3232E Command Reference

Other manuals for Kyocera KM-C3232E