PRESCRIBE Command Reference
256
RWRF R — [Read/Write Resource File] Read
Format
RWER R, medium, "PRN", 'partition-name';
Parameters
medium:
0 = hard disk
A = memory card
partition-name:
Name of partition from which data is read, a maximum of 15 printable ASCII characters
Function
The RWRF R command reads data specified by file name from any external media. The
data must be a printable data. When the file name is coexistent in both the hard disk and
memory card that are installed in the printing system, the printing system will read the
memory card first, then the hard disk.
The partition name may be a maximum of 15 printable ASCII characters (20H through
7EH); upper and lowercase letters are regarded as distinct. A partition name may not
have leading spaces, and in the command, the partition name must be enclosed in single
or double quotation marks.
The printing system will automatically' read or execute the data in the media if it is
stored under the file name of '02autostart' and saved in the PRE folder of the media. The
printing system will look for the file when it is powered up. The RWER R command is
not required.
This command causes a page break.
Example:
To read partition DataS001 from the hard disk:
!R! RWRF R, 0, "PRN", 'DataS001'; EXIT;
To Next Page
Loading...
Need help?
General
