MDAT
163
fuser-mode
0 = High
1 = Middle
2 = Low
3 = Vellum
duplex
0 = Enable
1 = Disable
density
1 = Light
2 = Medium Light
3 = Normal
4 = Medium Heavy
5 = Heavy
Function
The MDAT command is used to customize the default attributes of a media type for
optimization. The paper-weight attribute affects the printing system’s transfer bias,
fuser-mode affects the fuser temperature, and duplex determines whether the paper with
that paper type is allowed for duplex printing or not.
If the parameters paper-weight and fuser-mode are omitted, this command resets the
three attributes back to their defaults. If all the parameter are omitted (MDAT;), all the
attributes for the all media types are reset to the default.
File
To set the transparency paper type to the thick paper weight and the high fuser
temperature mode, disabling the duplex printing, command:
!R! MDAT 2, 1, 0, 1; EXIT;
Related Command
MTYP
To Next Page
Loading...
Need help?
General
