RWER W
251
1. Verify the printing system’s message display indicates Ready.
2. Enter the following at the DOS prompt:
C:\>ECHO !R! RWER W, A, 2, ’DATA123’; >PRN
The message display will change from Ready to Processing, and then to Waiting.
The printing system is now ready to receive data, so send the file from the computer to
the printing system.
3. To do this, enter the following at the DOS prompt:
C:\>COPY DATA123.DOC PRN
4. The message display will change to Processing as the file is written to partition
DATA123 on the memory card. Next, check that the message display has changed to
Waiting, and then send a WRED command, as follows:
C:\>ECHO WRED; EXIT, E; >PRN
The WRED command terminates writing to the memory card.
Note that in W mode the ICCD command is accompanied by a form feed.
If a partition name conflict occurs when writing a new partition to a memory card, the
name of the new partition will be modified as follows:
• If a partition name of 11 characters or less conflicts with an existing partition name,
‘Snnn’ (nnn represents a numeric value) is appended to the partition’s name.
• If a partition name of 12 or more characters conflicts with an existing partition name,
the 12th and following characters of the new partition’s name will be replaced by
‘Snnn’ (nnn represents a numeric value).
Related Command
WRED
To Next Page
Loading...
Need help?
General
