SPSZ
325
Function
The SPSZ command sets the paper edge limits to the dimensions of a standard paper
size, allowing for a 5 mm border of all sides. The margins are set to the edge limits. This
command is particularly useful for printing on envelopes (size-code 1 through 4, 16, and
17). If size-code is 0, the printing system adjusts the edge limits to match the cassette
size. size-code defaults to 0 at power-up and after a reset.
Size codes 10 through 12, 19, and 30 are supported only by the printing system model
that handles the A3 size paper. Support for other paper sizes and reduction ratios vary
depending on models. For details, see the user’s manual supplied with the printing
system.
If your printing system model supports the A3 size paper, the enlargement/reduction
ratio parameter controls reduction and enlargement of printing a page sized by the size-
code parameter. Although the enlargement/reduction ratio parameter is optional, an
enlargement/reduction ratio setting remains effective until an SPSZ command with new
enlargement/reduction ratio specified or a reset command is encountered.
Note that the enlargement/reduction ratio parameter is ignored unless the source paper
size and the cassette paper size does not match.
The SPSZ command causes a page break, so it should be placed at the top of a file or
program, or at the beginning of a new page.
Files
!R! CMNT Size the page as Monarch; SPSZ 1;
EXIT;
!R! CMNT Size the page as A3 and reduce it to A4;
SPSZ 10, 5;
EXIT;
!R! CMNT Size the page as letter and reduce it to
98%; SPSZ 6, 9;
EXIT;
To Next Page
Loading...
Need help?
General
