2NC/2NF/2NG/2NN/3P7/3P8/3P9
1-5-86
(1-1) Detaching and refitting the document processer
Procedure
1. Remove the DP connector cover using
flatscrew driver.
2. Remove the connector.
3. Remove the cable tie from the hole dur-
ing pinching both-side of it.
Figure 1-5-151
4. Remove the DP to upside from the main
unit.
5. Check or replace the DP and refit all the
removed parts.
Figure 1-5-152
Flatscrew
drivers
Hook
Hook
DP connector cover
Connector
Cable tie
DP interface wire
Cable tie
DP
Main unit
To Next Page
Loading...
