127Expert(t) 2000
TM
Maintenance Manual
Figure 188. Sample bottle probe tip
12. Install the probe on the coupler
to fill the sample bottle;
Figure 189. Sample bottle probe
13. Fill the bottle to the level mark
(Figure 190. “Sample bottle”);
Figure 190. Sample bottle
14. Remove any excess of oil
through the vent;
15. Once the sample is taken,
remove the probe from the
coupler and pull out the probe to
remove it from the bottle (Figure
191. “Probe removal from the
bottle”);
Figure 191. Probe removal from the
bottle
CAUTION
DO NOT OPEN THE BOTTLE CAP.
Probe Tip
Protective Cap
Probe
Recommended Oil Level
To Next Page
Loading...
