66 CHAPTER 3
Maintenance
Figure 105. Wiper blade
30. Once the packer is installed in
the hopper, install roller
assemblies and reverse the
procedure to reconnect the
hydraulic cylinders and re-install
both side rails;
31. Bolt the rails along the top edge
of the hopper wall (Figure 101.
“Side rail and deflector stand”);
32. Once finished re-assembling the
removed components, lubricate
and check for proper operation
of the packer.
Wiper Blade
(plastic)
Wiper Blade
DANGER
NEVER CLIMB IN THE HOPPER WHILE
THE
ENGINE IS RUNNING.
To Next Page
Loading...
