3. INSTALLATION
9
IMPORTATNT!! Follow the below steps before operating.
1. Before operating, lift up the scoring motor to remove the fixing wood block
from the machine. (Figure 3-1.1)
2. Put on the flat belt to the scoring shaft. Be aware of the movement direction
mark on the belt. (Figure 3-1.2) Follow the mark to set the belt.
3. Turn the wheel (see A of Fig.3-8.1) to make the whole motor unit 45° tilted.
(Figure 3-1.3)
4. Loosen motor plate knob (see arrow). (Figure 3-1.4)
5. Ch
eck if the belts are on the correct position to avoid rotational speed problem.
For example, if it’s set 4000rpm, 2 sides of the belt have to be set on the
4000rpm groove (Figure 3-1.5)
6. Rotate the handle to right hand side to tight the belts then lock the knob to
finish. (Figure 3-1.6)
Figure 3-1.5
Figure 3-1.1
Figure 3-1.2
Figure 3-1.3
Figure 3-1.4
Figure 3-1.6
Check position
To Next Page
Loading...