1. INFORMATION
5
20mm deep. Push blocks should be used when cutting small work
pieces and in circumstances where it is necessary to push the work
piece against the fence.
b) Selection of saw blade and riving knife- the operator should only select
saw blade with suitable diameter and thickness for the machine.
c) Selection of riving knife slot- The riving knife guiding slot should be no
more than 0.5mm wider than the riving knife guiding elements.
d) Fixing of saw blade to spindle- Where the spindle diameter is less than
the saw blade bore diameter, flanged bushes provided by the machine
manufacture should be used to make up the difference. The use of
loose rings or bushes is not permitted.
e) Lighting- it is important to provide adequate lighting around the
machine.
39) Guide the work piece along the rip fence and through the rotation saw
blade, using the push stick if necessary. Any damage, please replace new
one that specification according below drawing.
40) Do not operate this machine while tired or under the influence of drugs,
alcohol or any medication.
41) The dust generated by certain woods products can be injurious to
your health.
Always operate machinery in well-ventilated areas, and provide for proper
dust removal. Use wood dust collection systems whenever possible
42) Any other maintenance is welcome to be contacted manufacturer or our
distributor.
To Next Page
Loading...