123
9 Appendix
9.17 Switch- and Key Combinations
Action Display
Mode Buttons / Other
Recall correction range Status Monitoring display
Automatic
Setting
press key 11 (Enter)
Reset
press key 1 (Reset)
Code entry for parameter
settings
Status Automatic press keys 5, 7 and 8 simultaneously
Recall fault history Status Monitoring display
Automatic
Setting
press keys 2 or 3
(not in fault mode)
Recall correction input value Firing rate
value
press key 11 (Enter)
firing rate adjustable via
switch 1 (manual operation)
Automatic press key 12 (Hand)
Quit manual mode Automatic press key 12 (Hand) again
firing rate adjustable via
switch 1 (internal firing rate
presetting)
Firing rate
value
Setting press key 2 or 3
EG/ES mode is activated Firing rate
value
Setting press key 6 GL mode or RG
EG/ES mode is terminated Set point
Actual
value feed-
back
setpoint
feedback
Setting
_
press key 2.....9 to acknowledge in mode
EG or ES
Display of running time
meter / Starts counter
Automatic press key 10 (clock)
Store point
Setpoint
Actual
value
feedback
Setting press key 11 (Enter)
Delete present curve
Setpoint
Clear memory press key 11 (Enter)
Display of acceptance data,
CRCs for all levels, oil/gas
safety times, pre-purge time
Setpoint
feedback
Automatic
Setting
press key 11 (Enter)
Traverse channel
Setpoint
Setting
_
press key 2.....9
Scanning of serial no and
key no
Actual
value feed-
back
Automatic press key 11 (Enter)
Call up flame intensity Automatic press key 15 / F4 (M) twice
Without integral flame monitoring, the dis-
play shows "---%"
Mode switching with O
2
trim
ETAMATIC
Automatic press key 15 (M) twice
To Next Page
Loading...
