14
5 Commissioning
5 Commissioning
5.1 Before Commissioning
5.1.1 Basic Settings
First you must configure the device (ETAMATIC) for the requirements of the system.
Therefore, you have to set the following parameters.
We recommend to use the LAMTEC PC software for Windows (available separately).
The factory standard settings are indicated by *.
5.1.2 Password Entry
5.1.3 How to Change the Password
First enter the current password, see page chapter 5.1.2 Password Entry.
Press key 1
Press keys 5 and 7 and 8 simultaneously.
Enter with keys 2 to 9 the password (delivery status is 0000).
Press key 11 (ENTER).
Press key 17 until the display shows "Status"
Press keys 5, 7 and 8 simultaneously
The display shows an entry field.
Use the keys 2 to 9 to set the new password
Press key 16 until the display shows “digital inputs”
Press key 11 ENTER.
To Next Page
Loading...
