Lamtec ETAMATIC - Recalling Fault History; Calling up the Hour Counter

34
5 Commissioning
5.3.3 Recalling Fault History
The ETAMATIC stores the last 10 faults with the associated data of the running time counter.
Requirement: ETAMATIC must not be in fault condition.
NOTICE
If it is certain that the ETAMATIC has carried a voltage at all times since the last fault, it is pos-
sible, that from the present output of the running time counter and the current time, to deter-
mine at which time the fault occurred.
5.4 Calling up the Hour Counter
The total of running times for curve set 1and curve set 2 do not necessarily add up to the dis-
played total running time.
NOTICE
The total counter refers to the ETAMATIC 's running time. It starts timing as soon as the unit
is connected to a voltage source (this also provides the basis for the fault history).
The individual running time counters refer to the burner's running time. They start timing as
soon as the burner is in operation with the relevant curve set (flame signal is present).
Press key 17 until the display shows "Status".
Press key 3  the display shows the last fault code
Press key 11 (Enter)  the display shows the associated plain text and the running
time hours.
Press key 3 again  the display shows the last but one fault code.
Press keys 3 and 2 to browse through the fault history.
press key 10  the display shows the running text of the following data succes-
sively:
Total running time
Running time on curve set 1
Starts on curve set
Running time on curve set 2
Starts on curve set 2
Running time on curve set 3*
Starts on curve set 3*
Running time on curve set 4*
Starts on curve set 4*
* if parameterised