Lancom GS-2310P - Page 139

The description of the device. In this case: “44-Port 10/100/1000Base-T + 4 (100/1G) SFP Combo + 4 (1G/10G) SFP+
PoE+ L2 Plus Managed Switch”.
Location:
The physical location of the switch. User-defined.
Contact:
For easy managing and maintenance of the device, you may enter the name of a contact person and a phone number
here. You can configure this parameter through the device’s user interface or SNMP.
Device name:
The name of the switch. User-defined.
System Date:
Shows the system time of the switch. Its format: day of week, month, day, hours: minutes: seconds, year.
System up time:
The time accumulated since this switch has been powered up. Its format is day, hour, minute, second.
BIOS version:
The version of the BIOS in the switch.
Firmware version:
The firmware version in the switch.
Hardware-Mechanical version:
The version of the electronic and the mechanical hardware. The figure before the hyphen shows the version of electronic
hardware; the one after the hyphen show the version of mechanical hardware.
Serial number:
The serial number of the switch.
Host IP address:
The IP address of the switch.
Host MAC address:
The ethernet MAC address of the management agent in the switch.
Device Port:
Shows all types and numbers of the port in the switch.
RAM size:
The size of the RAM in the switch.
Flash size:
The size of the flash memory in the switch.
Bridge FDB size:
Displays the bridge FDB size information.
Transmit Queue:
Displays the transmit hardware priority queue information.
Maximum Frame size:
Displays the maximum frame size information.
139
LANCOM GS-2310P/GS-2326(P) User Manual
4 System Configuration