Lancom GS-2310P - Radius Details

The current state of the server. This field takes one of the following values:
Disabled: The server is disabled.
Not Ready: The server is enabled, but IP communication is not yet up and running.
Ready: The server is enabled, IP communication is up and running, and the RADIUS module is ready to accept accounting
attempts.
Dead (X seconds left): Accounting attempts were made to this server, but it did not reply within the configured timeout.
The server has temporarily been disabled, but will get re-enabled when the dead-time expires. The number of seconds
left before this occurs is displayed in parentheses. This state is only reachable when more than one server is enabled.
Auto-refresh:
Activate the auto-refresh to refresh the information automatically.
Refresh:
Refresh the RADIUS Status manually.
5.6.3 Radius Details
This section provides detailed statistics of the RADIUS Authentication and Accounting servers. The statistics map closely
to those specified in RFC4668 - RADIUS Authentication Client MIB.
To configure RADIUS Details in the web interface:
1. Specify Port which want to check.
2. Checked “Auto-refresh”.
Figure 5-6.3: The RADIUS Authentication Statistics Server
Parameter description:
Auto-refresh:
Activate the auto-refresh to refresh the information automatically.
Refresh:
Refresh the RADIUS Statistics information manually.
185
LANCOM GS-2310P/GS-2326(P) User Manual
5 Security