Lancom GS-2310P - Static Table

Mode of ARP Inspection Configuration:
Enable the Global ARP Inspection or disable the Global ARP Inspection.
Port Mode Configuration:
ARP Inspection is enabled on selected ports. Only when both Global Mode and Port Mode on a given port are enabled,
ARP Inspection is enabled on this given port.
Buttons:
Save – Click to save changes.
Reset – Click to undo any changes made locally and revert to previously saved values.
5.2.2 Static Table
The section describes how to configure the Static ARP Inspection Table parameters of the switch.
To configure a Static ARP Inspection Table in the web interface:
1. Click “Add new entry”.
2. Specify the Port, VLAN ID, IP Address, and MAC address in the entry.
3. Click Apply.
Figure 5-2.2: The Static ARP Inspection Table
Parameter description:
Delete:
Delete the entry. It will be deleted during the next save.
Port:
The logical port for the settings.
VLAN ID:
The vlan id for the settings.
MAC Address:
Allowed Source MAC address in ARP request packets.
IP Address:
Allowed Source IP address in ARP request packets.
164
LANCOM GS-2310P/GS-2326(P) User Manual
5 Security