Indicates the SSH mode operation. Possible modes are:
Enabled: Enable SSH mode operation.
Disabled: Disable SSH mode operation.
Buttons:
Save – Click to save changes.
Reset – Click to undo any changes made locally and revert to previously saved values.
5.10 HTTPs
This section shows how to use HTTPS to securely access the Switch. HTTPS is a secure communication protocol that
combines authentication and data encryption to provide secure encrypted communication via the browser.
Web Interface
To configure a HTTPS in the web interface:
1. Select “Enabled” in the Mode of HTTPS Configuration.
2. Select “Enabled” in the Automatic Redirect of HTTPS Configuration.
3. Click Apply.
Figure 5-10.1: The HTTPS Configuration
Parameter description:
Mode:
Indicates the HTTPS mode operation. Possible modes are:
Enabled: Enable HTTPS mode operation.
Disabled: Disable HTTPS mode operation.
Automatic Redirect:
Indicates the HTTPS redirect mode operation. Automatically redirect web browser to HTTPS when HTTPS mode is enabled.
Possible modes are:
Enabled: Enable HTTPS redirect mode operation.
Disabled: Disable HTTPS redirect mode operation.
5.11 Auth Method
This page shows how to configure the user authentication method of the switch.
Web Interface
194
LANCOM GS-2310P/GS-2326(P) User Manual
5 Security
To Next Page
Loading...
