Figure 3-6.1: The MLD Snooping Basic Configuration (GS-2310P)
Parameter description:
Snooping Enabled:
Enable the Global MLD Snooping.
Unregistered IPMCv6 Flooding enabled:
Enable unregistered IPMCv6 traffic flooding. Please note that disabling unregistered IPMCv6 traffic flooding may lead
to failure of Neighbor Discovery.
MLD SSM Range:
SSM (Source-Specific Multicast) Range allows the SSM-aware hosts and routers run the SSM service model for the groups
in the address (Using IPv6 Address) range.
Proxy Enabled:
Enable MLD Proxy. This feature can be used to avoid forwarding unnecessary join and leave messages to the router side.
Port:
The Port index what you enable or disable the MLD Snooping function.
Fast Leave:
Activate to enable the fast leave on the port.
Router Port:
Specify which ports act as router ports. A router port is a port on the Ethernet switch that leads towards the Layer 3
multicast device or MLD querier. If an aggregation member port is selected as a router port, the whole aggregation will
act as a router port.
Throttling:
Enable to limit the number of multicast groups to which a switch port can belong.
Buttons:
52
LANCOM GS-2310P/GS-2326(P) User Manual
3 Configuration
To Next Page
Loading...
