Parameter description:
Delete:
To delete a MAC-based VLAN entry, check this box and press save. The entry will be deleted on the selected switch.
MAC Address:
Indicates the MAC address.
VLAN ID:
Indicates the VLAN ID.
Port Members:
A row of check boxes for each port is displayed for each MAC-based VLAN entry. To include a port in a MAC-based VLAN,
check the box. To remove or exclude the port from the MAC-based VLAN, make sure the box is unchecked. By default,
no ports are members, and all boxes are unchecked.
Adding a New MAC-based VLAN
Click to add a new MAC-based VLAN entry. An empty row is added to the table, and the MAC-based VLAN entry can be
configured as needed. Any unicast MAC address can be configured for the MAC-based VLAN entry. No broadcast or
multicast MAC addresses are allowed. Legal values for a VLAN ID are 1 through 4094.
The MAC-based VLAN entry is enabled on the selected switch unit when you click on "Save". A MAC-based VLAN without
any port members on any unit will be deleted when you click "Save".
The button can be used to undo the addition of new MAC-based VLANs.
Buttons:
Save – Click to save changes.
Reset – Click to undo any changes made locally and revert to previously saved values.
Status
This section shows MAC-based VLAN entries configured by various MAC-based VLAN users. Currently we support following
VLAN User types:
NAS: NAS provides port-based authentication, which involves communications between a Supplicant, Authenticator,
and an Authentication Server.
Web Interface
To display MAC-based VLAN configured in the web interface:
1. Click MAC-based VLAN Status.
2. Specify the Staic NAS Combined.
3. Display MAC-based information.
Figure 3-10.6.2: The MAC-based VLAN Membership Status for User Static (GS-2310P)
90
LANCOM GS-2310P/GS-2326(P) User Manual
3 Configuration
To Next Page
Loading...
