Lancom GS-2310P - Page 98

Parameter description:
Port:
The Port column shows the list of ports for which you can configure GARP settings. There are 2 types configuration
settings which can be configured on per port bases.
Timer Values
Application
Attribute Type
GARP Applicant
Timer Values:
Three different timers can be configured on this page:
Join Timer: The default value for Join timer is 200ms.
Leave Timer: The range of values for Leave Time is 600-1000ms. The default value for Leave Timer is 600ms.
Leave All Timer: The default value for Leave All Timer is 10000ms
Application:
Currently supported applications:GVRP.
Attribute Type:
Currently supported Attribute Type is VLAN.
GARP Applicant
This configuration is used to configure the Applicant state machine behavior for GARP on a particular port locally.
normal-participant: In this mode the Applicant state machine will operate normally in GARP protocol exchanges.
non-participant: In this mode the Applicant state machine will not participate in the protocol operation.
The default configuration is normal participant.
Buttons:
Save – Click to save changes.
Reset – Click to undo any changes made locally and revert to previously saved values.
98
LANCOM GS-2310P/GS-2326(P) User Manual
3 Configuration